| Uploader: | Moogular |
| Date Added: | 21 October 2010 |
| File Size: | 23.12 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 66564 |
| Price: | Free* [*Free Regsitration Required] |
Systems intending to use WOL should be connected to a switch capable of both and 10 or speeds.
Browdcom virtual adapter is created for each VLAN added. Other protocol packets will be sent and received through one primary NIC only. All primary interfaces in a team will participate in Load-balancing operations by sending and receiving a portion of the total traffic.
This chapter provides the following information: ACT Blinking Brief bursts of data detected on the port. Inform your network supplier of any missing or damaged items.
Keep the adapter in its packaging until ready for installation. Refer to " Linux Driver Software " for additional information.
DELL GIGABIT ETHERNET 10//BT PCI-X BROADCOM -
Select check the driver or drivers of choice. No 10 Mbps link; possible link at different speed, possible bad cable, bad connector, or configuration mismatch. Off No data bbroadcom on the port. Smart Load-balance SLB mode works with all Ethernet switches without configuring the switch ports to any special trunking mode.
Load Balance - All Broadcom.
DELL GIGABIT ETHERNET 10/100/1000BT PCI-X BROADCOM 5703
Off No link; possible link at different speed, possible bad cable, bad connector, or configuration mismatch. Dell supports Wake on LAN on one device in the system at a time.
The following options are supported under Windows Server These features are provided by creating teams virtual adapters that consist of multiple NIC interfaces.
The Setup Needs the Next Disk screen will appear.
Create driver disks using the Broadcom MakeDisk utility setup. Only IP traffic will be load-balanced in both inbound and outbound directions.
If you need to return the adapter, you must pack it in the original or equivalent packing material or the warranty will be voided. Antistatic bag used for protecting the adapter when stored or shipped.
Broadcom Advanced Server Program Overview. If more than one driver was selected, the Setup Needs the Next Disk screen will appear again. Standby interfaces will take over in the event that all primary interfaces have lost their links. The Generic Trunking mode requires the Ethernet switch to support some form of port trunking mode e.
To create a driver disk, perform the following: No Mbps link; possible link at different speed, possible bad cable, bad connector, or configuration mismatch.
Load Balance - Multivendor. Please read all restrictions and disclaimers. All the physical broadvom in the Note that selecting multiple drivers will result in creating multiple disks. IPX traffic will be load-balanced in outbound direction only.
Refer to " Broadcom Advanced Control Suite " for additional information. The following options are supported under Windows
Comments
Post a Comment